Fiberglass Reinforced Polypropylene Tank
The Clean & Clear Plus filter combines top-end filter performance with low maintenance. This dependable design uses special filter elements to strip tiny particles from your pool water…particles as small as 20 microns (an average grain of beach sand is 1,000 microns). Our four-cartridge design provides maximum filter surface area to capture more dirt and extend time between cleanings. And cleaning is a snap—open the top, remove the cartridges, hose them off and the Clean & Clear Plus filter is ready to go again.
Clean & Clear® Plus Cartridge Filters have a corrosion resistant injection molded filter tank featuring superior strength and reliability. The cartridge assembly uses four easy to clean, non-woven, polyester cartridges. Each filter is supplied with a bulkhead union set for easy installation.
Features:
- NSF listed
- Superior strength
- Large filter area for increased dirt capacity
- 1-1/2 in., 100% drain clean-out port
- Continuous High Flow™ internal air relief*
- Base and plumbing kits now available
- Injection molded tank
- Balanced hydraulic flow
- Tension Control™ clamp
- 100% factory tested
- Black bulkhead unions
- High Flow manual air relief valve
Four Cartridges in a Compact Design
Clean & Clear Plus filters contain four polyester cartridges that
hold enormous amounts of dirt, yet are easier to clean. The
fiberglass-reinforced tank halves are secured with an innovative
clamp ring—just loosen the ring and remove the top half for
easy cartridge access and rinsing. Filter maintenance doesn’t
get any easier.
- Continuous internal air bleed helps prevent air build-up
- to keep the filter operating at peak performance.
- Single-piece base and body for strength, stability and
- years of dependable service.
Note: Actual system flow will depend on plumbing size and other system components.
Note: Pentair Pool Products does not recommend flow rates above 150 GPM.
*Integrated Continuous High Flow internal air relief is operational only when there is unobstructed flow in the circulating system.
Operating Limits - maximum continual operating pressure of 50 PSI. Pool.spa (bather) applications, maximum operating water temperature (internal filter) 104 degrees F (40 degrees C)
Flat Rate Shipping - $75.00
